Shipping Dimensions:5.3 x 5.3 x 4.8 in
-Record stereo audio at 24-bit, 96kHz*
-Matched pair of 1/2" cardioid condenser capsules
-Metal casing for enhanced durability and electromagnetic interference immunity.
-Includes windshield, zip case
-Software-switchable 72Hz high pass filter for reduction of unwanted low frequency noise.The RØDE i-XY is the ultimate recording microphone for iPhone® and iPad®. With up to 24-bit/96k* recording and on-board high-fidelity A/D conversion, your i-XY recordings are rich, smooth and accurate. At the heart of the i-XY is a matched pair of ½” cardioid condenser capsules, fixed in a perfect 90 degree ‘near-coincident’ alignment.
This results in immersive and true-to-life stereo recordings, captured in incredibly high detail. Designed and manufactured in Australia, the i-XY is available in two versions - Lightning and 30-pin. The Lightning version supports the iPhone® 5s, iPhone® 5 and iPhone® 5c. The 30-pin version supports the iPhone® 4S, iPhone® 4, iPad® (3rd generation) and iPad® 2. A foam windshield is supplied for outdoor recording as well as a reinforced protective zip case to ensure your i-XY is available whenever you need it.
-Connector Apple Lightning connector
-Acoustic Principle Pressure gradient
-Active Electronics JFET impedance converter
-24-bit 96 kHz A/D converter
-Capsule 2x 0.50" (1.3 cm) condenser
-Polar Pattern Paired cardioid capsules in XY pattern
-Address Type End
-Frequency Range 20 to 20,000 Hz (selected HPF at 0)
-High Pass Filter 72 Hz in software
-Output Impedance 0 Ohms
-Maximum SPL 122 dB SPL (at 1,000 Hz and 1% THD into 1 kOhms load)
-Sensitivity -34 dB re 1V/Pa (19.7 mV at 94 dB SPL) ± 2 dB at 1,000 Hz
-Equivalent Input Noise 17 dBA (A-weighted)
-Signal to Noise Ratio 76 dBA SPL (as per IEC651)
-Power Requirements Powered from device