Omnia MPX Node is a building-block technology that helps stations leverage the growing power and capability of data networking. The Omnia MPX Node is the first purpose-built hardware codec capable of sending or receiving full FM signals at data rates as low as 320 kbps utilizing the Omnia μMPXTM algorithm, ideal for networks with limited capacity (including IP radios). MPX Node makes peak-controlled L/R baseband, stereo pilot, and RDS data routable from a studio to one or many FM transmitters.
By transporting an FM composite signal rather than left/right audio, broadcasters can keep their on- air processing and RDS encoding at the studio, then deliver a transmission-ready, peak controlled FM multiplex signal directly to an FM transmitter without the need for transmitter-side peak limiting or stereo generation. The MPX Node is available as either an encoder or decoder, and a pair of units creates an end-to-end system.
MPX Node is available as either an Encoder or Decoder
Omnia μMPX algorithm can transport FM composite (MPX) and RDS/RBDS at selecta variable rates from 320 kbps up to 576 kbps —perfect for IP radios and DSL IP circuits and other lower bandwidth connections
Built-in, configurable error correction
Processor agnostic design: Encoder can be fed by any brand of FM audio processor
Omnia.9 or OmniaSSTTM processing software can serve as the Encoder front end
MPX Node Decoder outputs a standard analog MPX signal to feed any FM transmitter
Full FM signals (including RDS/RBDS) can be sent over IP networks
5 In x 5 Out GPIO
A single Encoder can transmit the same signal to multiple decoders
Separate Ethernet ports support independent, dual networks
Redundant networking allows the same signal be sent/received over two ISP’s
Simple HTML.5-based web GUI allows you to control MPX Node from your desktop, tablet, or smartphone
Dual bank firmware update design, for secure upgrading
Integrated test signal generator
Cool-running, fanless operation
Half RU, xNode form factor
Specifications
Analog composite FM in/out on (BNC connector)
Composite connector impedance 5 or 75 ohm (switch selectable)
Net 1 port provides 10/100/1000 Ethernet
Net 2 port provides 10/100 Ethernet
Both Network ports support MPX transmission, web control and redundant streaming
5 in x 5 out GPIO on a DB15 connector
100-240 VAC input 50-60 Hz external power supply with 12VDC, 3.4A output on locking connector
8.5” (22 cm) wide; two may be mounted side-by-side in a standard 1RU rack space with accessory mounting kit; 1.72” (4.4 cm) height, 11.75” (30 cm) depth
Operating temp range 0 to +40 degrees C, <90% humidity